![]() ![]() Installed easily, lots of room, almost an inch shorter than the 10ah batteries. Being this late in the season I decided to take the cheap way out and replace with the cheap, and easily available 12v 7ah batteries. The most annoying problem was that the wire connectors were also soldered to the battery terminals, required a very powerful soldering iron and see-saw tension to remove. Extreme care must be taken when reassembling pack, wire placement is slightly difficult-tricky, many wires and very little room. Battery pack comes apart easily, 5 screws, very tightly packed with 2-10ah batteries and several wires. Anything that loosens up add one of these and re tighten.Īfter 100 charge-discharge cycles my batteries have finally given out, noticeably decreased speed after a couple miles. Next time you're at the hardware store buy a small handful of 1/4" "split" lock washers, 2 cents each. Cutting a 16D common nail should also work.Ģ. I found a tight replacement pin at local hardware store 3/4" x 3/16" approx. The pin retains a spring
0 Comments
Leave a Reply. |